September 15, 1961
Bulletin No. SB-868
Shroud Groups
SUBJECT: Replacement of #377582 rubber mounts -
lower motor cover support.
10 h.p. QD (L)-20 thru 23,
18 h.p. FD (L)-13 thru 16,
28 h.p. RX (L)-10C
PROCEDURE TO REMOVE RUBBER MOUNTS:
1. Remove all rubber mount nuts (8) #302103 and lockwashers (8) #306799.
2. Starting with starboard rear mount, raise lower cover up so maximum
clearance is obtained and remove mount, then remove both front mounts
in same manner.
3. To remove rear port mount carefully insert large screwdriver, or other
lever, between lower cover and exhaust housing flange and deflect cover
upward until mount can be removed. CAUTION - TOO MUCH PRESSURE WILL
DAMAGE COVER.
4. When installing mounts, use the same procedure as was used for removal,
except, start with the rear, port mount.
5. Lockwashers and nuts may be replaced when all mounts have been installed.
6. To replace one or four mounts, all mount nuts and lockwashers must be
removed.
JOHNSON MOTORS
W. W. DeWees
Service Department
WWD:eb
NOTE: Post on your QD, FD & RX indexes.