SPB #358 Revised - Time Saving Service Tools

Johnson Motors Service Promotion letterhead

SPB #358 Revised

June, 1965

SUBJECT: TIME SAVING SERVICE TOOLS.

Here is that hard to find 2-1/16 inch hole saw required for ammeter installation. The hole saw may be purchased separately, or as an assembly with mandrel. The saw will fit a standard mandrel with 5/8-18 thread.

Your cost is -

1. Mandrel and Hole Saw assembly . . . $8.90 net
2. Hole saw only . . . $4.95 net
3. Mandrel only . . . $3.95 net

Those of you that have been to the Factory Service School are familiar with the three cornered scraper being demonstrated here. This tool has many uses, removing carbon, cleaning gasket surfaces, etc.

Part number and your cost is -

No. 15 Bearing Scraper $1.55 net

Allen bit used for Electramatic drive spring screws

A Allen Bit required to apply proper torque (15-20 inch lbs.) on set screws holding Electramatic drive springs. Proper torque and the application of Loctite on these set screws is a must. The Allen Bit is available separately, or with a 1/4 inch 3/8 drive locking socket holder.

Part numbers and your costs are -

185-0 Allen Bit . . . $.65 net
TW8 1/4 inch 3/8 drive socket . . . $1.30 net
Allen Bit and Socket Assembly . . . $1.95 net

MAC XD 102T deep socket for connecting rod screws

A deep socket for connecting rod screw #308186 - 40, 60, 75, 90 HP engines. This thin wall deep socket is made to withstand the 29 to 31 Ft. Lbs. of torque required on these screws.

Part number and your cost is -

MAC XD 102T Deep Socket - $1.40 net

OVER

The occasion arises, from time to time, when a long shaft engine has to be converted to short. Here is the perfect tool for getting up in there and shortening those water tubes without having to remove the powerhead. Remember - cut off exactly five (5) inches - no more, no less.

Part number and your cost is -

127-F Tube Cutter .... $2.25 net

Have you ever wished you had a 3/8"-1/2" curved box end wrench that you could work around the corner with? Well - here is the one you have been looking for. There is no end to the uses for this wrench. Especially useful in removing that bottom retaining bolt on the V-4 starters.

Part number and your cost is -

S-108 Half-moon Wrench - $1.45 net

These Time Saving Service Tools ARE NOT available from Johnson Motors as special Service items. We do know, however, there is a need for them, as indicated by your requests.

Your order for any or all of these tools must be sent to:

Simon's Tool Sales
1015 Fulton Avenue
Winthrop Harbor, Illinois

Net prices, as shown, is your complete cost postage prepaid
(Illinois residents add 4% Sales Tax).

Jack Penland
JOHNSON MOTORS
Service Promotion Manager

P.S. Please do NOT send your order to Johnson Motors.

NOTE: Destroy Service Promotion Bulletin #358, dated February 24, 1964.

JP:rs

Earlier edition

This June 1965 revision superseded the February 24, 1964 edition. View the original SPB #358, preserved for historical reference.

Modern availability: service tools

The original bulletin describes a 2-1/16-inch hole saw for ammeter installation. This size is still available from modern tool suppliers. The bulletin also specifies a thin-wall deep socket for connecting rod screw #308186.

Amazon affiliate links. Check hole saw arbor and thread compatibility. The original MAC XD 102T was a thin-wall socket; verify outside diameter and clearance before ordering a replacement.