Evinrude Service Bulletin #1064 - Electric Trolling Motor Service Tips

Issued November 1974, this Evinrude bulletin explains heat-sink compound application for EB-12S trolling motor transistor replacement, sealing the motor adaptor, and correcting bow-mount latch rope wear.

Evinrude Service Bulletin header
MISCELLANEOUS #1064
November, 1974
ELECTRIC TROLLING MOTOR SERVICE TIPS
Recently we have received some reports of replacement transistors P/N #387034 on EB-12S models (12 volt bow mount) failing on first use after installation. In all cases the mechanics did not refill the cavity opening of the adaptor housing with Dow Corning #340 Silicone Heat Sink Compound or Wakefield Engineering Compound #122 as directed in the instruction sheet for the Transistor and O-ring package. This silicone compound is available at local electronics supply houses. If silicone compound is not available locally contact:
Newark Electronics
500 N. Pulaski Rd.
Chicago, Illinois
60624 (312) 638-4411
Dow Corning
4825 N. Scott Street
Schiller Park, Ill.
60176 (312) 671-3100
When reassembling the motor to the adaptor be sure to apply OMC adhesive-m P/N #318535 to the surface marked (3) to assure a water tight fit. (Figure 1)
A frayed latch release rope on the bow mount models may be caused by burrs in the eyelet in the bow arm. (Figure 2) The burrs can be removed by using emery or crocus cloth.
When replacing the latch release rope on the bow mount electric outboard tie a knot on the end of the rope where it is attached to the latch in the mounting bracket to keep it from slipping through the tie strap. (Figure 3)
Figure 1
Figure 1: motor adaptor, O-ring, red and green leads
(over)
Figure 2: latch release rope and burr location
Figure 2
Figure 3: rope tie strap location
Figure 3
EVINRUDE MOTORS
Service Department

Back to 1970s service bulletins