Evinrude Bulletin 1069

Evinrude explains the correct throttle cam roller pickup marks after installation of carburetion improvement kit 387256.

Evinrude Service Bulletin header
FUEL SYSTEM #1069

January, 1975

THROTTLE CAM CHANGE FOR 1974 & 1975 15 HP MODELS
Throttle cam and roller adjustment, showing cam adjustment screws and cam mark
Fig. 1 is from 1975 Service Manual

We have received several complaints of 1974 15 HP engines idling erratically after installation of the #387256 Carburetion Improvement Kit. We have found that the mechanics have become confused by the written instructions for adjusting the throttle cam on Page 3-9 of the 1974 and 1975 15 HP service manuals.

The throttle cam supplied in the Carburetion Improvement Kit and on 1975 15 HP engines was redesigned by changing the ramp angle and by moving the cam roller pickup point. In order to have these cams available as quickly as possible, the first ones were made by modifying 1974 parts. Modified cams are easily identified since they are sprayed with a red coloring. On these early cams there is a scribe mark which is used as the cam roller pickup point. See Figure 1.

Since there is also a raised boss on the leading edge of these early cams, some mechanics have mistaken the boss for a Vee shaped mark. If the roller is adjusted to this boss instead of the scribe mark, the engine will run erratically at slow speed.

Throttle cams now being made come from their own die and these parts will have a Vee shaped mark rather than a scribe mark. These latest cams do not have the red coloring but do have part number 320819 cast into them.

Make a note on page 3-9 of your 1974 15 HP service manual that engines with the Carburetion Improvement Kit should have the cam roller set to the scribe mark. Make a note on page 3-9 of your 1975 15 HP service manual that these engines have the cam roller set to either the scribe mark (early production) or Vee shaped mark (late production).

EVINRUDE MOTORS
Service Department