Evinrude Ignition Service Bulletin #1076 (March 1975)

Pulse pack service tips for 1967-1970 100 and 115 H.P. models. This bulletin explains a blocking-diode repair for 1969-1970 115 H.P. ignition safety circuits and identifies compatible pulse packs, rotors and voltage suppressors for 1967-1968 100 H.P. engines.

Evinrude Service Bulletin header
IGNITION #1076
March, 1975
PULSE PACK SERVICE TIPS FOR
1967-1970  100 & 115 H.P. MODELS

I.   There have been several isolated reports of 1969 and 1970 115 H.P. engines equipped with the ignition safety circuit which, after having a replacement pulse pack (P/N 385038) installed, will not start or will start only with great difficulty. However, when the safety circuit is by-passed with a jumper lead between the 7 and 8 or 9 terminals of the terminal block, the engine starts and runs in a normal manner.

If you experience this problem, it can be corrected by adding a blocking diode (P/N 383538) which has to be modified by splicing on longer leads and terminals. Connect the diodes' purple/green stripe lead to terminal 7 of terminal block. Connect diodes' purple lead to starter solenoid at same terminal where heavy starter motor lead is connected. See Fig. 1. Secure diode to by-pass cover with a clamp.

NOTE

Be sure to remove the temporary jumper lead between 7 and 8 or 9 terminals so that safety circuit will function properly.

Figure 1: ignition safety circuit, blocking diode and terminal block wiring
(over)
Ignition #1076
II.   The chart below combines information from Service Bulletin 950 and Service Bulletin 1020. Make sure the rotor used is as indicated in the chart. The correct rotor is supplied with the phase II packs. Also, make sure the voltage suppressor is removed when a phase II pack is installed.
Compatibility chart for 1967 and 1968 100 HP ignition packs, rotors and voltage suppressors
NOTE: This bulletin replaces Ignition Bulletin #950 and #1020.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 385038

Search for original or compatible replacement part 385038. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.