Evinrude Service Bulletin #1087: Gearcase Field Modification Identification For 1975 70, 85, 115 And 135 H.P. Models

This June 1975 factory bulletin explains how to mark gearcases and serial-number plates after the improved shift rod and plunger assembly is installed on 70, 85, 115 and 135 HP models.

Evinrude Service Bulletin header
LOWER UNIT #1087
June, 1975
GEARCASE FIELD MODIFICATION IDENTIFICATION FOR 1975 70, 85, 115 and 135 H.P. MODELS

We have received many field reports that the "T" has not been added to the serial number plate and gearcase after installing the improved shift rod and plunger assembly. Be sure to scribe or stamp a "T" in both areas of all engines after kit is installed. We selected the letter "T" so that a small screwdriver or sharp chisel could be used if the dealership doesn't have a steel letter stamp set.

Anyone servicing the engine in the future, can easily identify it as one that has already been modified.

Note: Instruction sheet, page 8, "Marking Engine" shown below:

MARKING ENGINE

1. To properly identify engines which have been modified, stamp the letter "T" on the model/serial number plate immediately after the serial number. Also, stamp a "T" on the gearcase approximately ⅛ to 1" in front of the upper oil drain screw.

EVINRUDE MOTORS
Service Department