Evinrude Service Bulletin #1088: Tempo Tiltamatic

This June 1975 bulletin warns against replacing original Evinrude shock absorbers with Tempo Tiltamatic units because factory testing identified possible structural damage.

Evinrude Service Bulletin header
ACCESSORIES #1088
June, 1975
TEMPO TILTAMATIC

We have been questioned by dealers and customers as to the compatibility of the Tempo Tiltamatic shock absorber replacement (Tempo Products Company, Cleveland, Ohio) with pre-1975 Evinrude shock absorber equipped motors.

As the result of tests performed by our Marine Engineering group, we have found that the substitution of the Tempo Tiltamatic for one of the standard Evinrude shock absorbers can seriously effect the stability and safety of the motor in the event an underwater object is struck. If an underwater object is struck, it is quite probable that structural damage to the motor may occur.

In the tests performed using a production Tempo Tiltamatic shock absorber, damage to the following was observed:

Shock absorber attachments
Swivel Bracket
Exhaust housing adaptor
Attachment of powerhead to lower unit

Therefore we can not recommend substituting the Tempo Tiltamatic shock absorber for the production shock absorber on any Evinrude outboard motors.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim & Tilt Hydraulic Fluid & Spanner Wrench

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.