Evinrude Service Bulletin #1089: Water In Power Packs Of 1973 Thru 1975 50 Thru 135 Hp Models

This June 1975 ignition bulletin describes water intrusion in 1973-1975 power packs, diagnostic checks, and sealing the motor-cover tilt handle.

Evinrude Service Bulletin header
IGNITION #1089
June, 1975
WATER IN POWER PACKS OF 1973 THRU 1975 50 THRU 135 HP MODELS

Inspection of power packs returned to us on warranty recall has shown that many of the packs are good. We have found signs of water in many of them which could have led to temporary grounding of the components resulting in an erratic or inoperative condition.

When an OMC power pack tests bad be sure that there isn't any water between cover and interior terminals. When water is found, dry and clean the pack and terminals and retest pack.

We believe that the water is entering the pack by dripping through the holes around the screws in the tilt handle at the back of the motor cover. This usually happens when the engine is stored outside in a tilted position.

When this condition is experienced seal the holes at the tilt handle of the motor cover with OMC Sea Caulk, OMC Adhesive M or other effective marine sealer.

EVINRUDE MOTORS
Service Department