Evinrude Service Bulletin #1090: Clutch Dog Pin Spring P/N 313454 Or 320311 For 50 - 135 H.P. Models

Evinrude advised replacing clutch dog pin retaining springs after removal to prevent gearcase damage caused by stretched springs.

Evinrude Service Bulletin factory header
LOWER UNIT #1090
June, 1975
CLUTCH DOG PIN SPRING P/N 313454 OR 320311 FOR 50 - 135 H.P. MODELS

We are now recommending that the spring which retains the clutch dog pin (P/N 313454 or 320311) be replaced whenever it is removed from the clutch dog. We are making this recommendation since it is possible that, during removal, the spring may be accidentally stretched to the point where it will take a permanent set. A spring which has taken a permanent set loses a certain amount of its elasticity. If this spring is reused, it may expand during engine operation (due to centrifugal force acting on the spring) striking the pinion gear or nut resulting in extensive gearcase damage.

EVINRUDE MOTORS

Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump & Seal Puller Tool

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 313454

Search for original or compatible replacement part 313454. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.