Evinrude Service Bulletin #1102: Lifting the 1976 V-6 Engine

Issued September 1975, this factory bulletin explains the lifting eye and flywheel puller arrangement and the procedure for removing a 1976 V-6 outboard from its shipping carton.

Evinrude Service Bulletin
ENGINE MOUNTING #1102
September, 1975
LIFTING OR REMOVING 1976 V-6 ENGINE FROM SHIPPING CARTON
I.   LIFTING ENGINE
Unlike other large horsepower engines in our line, the V-6 does not come equipped with a lifting bracket. To hoist this engine, we have developed a lifting eye (P/N 321537) which is used with your flywheel puller (P/N 378103). The lifting eye should be attached as shown. See Figure 1.
NOTE

Make sure three puller screws are threaded in until shoulders contact flywheel. Insert lifting eye, center it on crankshaft and thread in until it is snug.

You will find that, by placing the lift point above the crankshaft centerline, the engine will hang straighter and will be easier to install or remove from the typical boat transom. (The lifting eye is an OMC Special Tool available through your regular parts supplier.)

Factory figure1 illustration
II.   REMOVING ENGINE FROM SHIPPING CARTON

Because of the height and weight of the V-6, removing the engine from the shipping carton may prove difficult. One way to remove these engines with a minimum of effort or chance of damage is as follows:

1. Lay the carton on its side. See Fig. 2.

Factory figure2 illustration
Engine Mounting #1102

2. Slit the tape on lower end of box and pull flaps apart.

3. Cut the banding strap from the upper end of box and remove cap.

4. Slit the box from end to end. See Figure 3.

Factory figure3 illustration
Factory figure4 illustration

5. Remove the propeller, gas tank and remote control.

6. Remove the supporting corrugated cardboard from around powerhead and gearcase.

7. Remove motor cover and assemble lifting eye and flywheel puller to engine as described in “I. LIFTING ENGINE” above. See Figure 1. Hoist engine to vertical position. See Figure 4.

EVINRUDE MOTORS

Service Department