Evinrude Fuel System Service Bulletin #1103 (October 1975)
This factory bulletin describes fuel-pump pressure checks and corrections for permanently installed fuel tanks used with 1976 Evinrude V-6 outboards. It addresses fuel-line restrictions, anti-siphon valves, primer bulbs, and fuel-pressure testing.

FUEL SYSTEM #1103
October, 1975
PERMANENTLY INSTALLED FUEL TANKS USED WITH 1976 V-6
▣ NOTE
Built in fuel systems must be checked for
restrictions as part of normal motor installation.
restrictions as part of normal motor installation.
When permanent installed fuel tanks are used, some anti-siphon valves, primers, filters, etc. may present restrictions greater than can be tolerated by the engine fuel pumps. Too great a restriction could reduce fuel flow to the engine resulting in poor performance and possible engine damage. To check for restrictions, the following steps should be followed.
1. FUEL PUMP PRESSURE TEST
Install an automotive fuel pump testing gauge in the fuel line between the fuel pump outlets and the carb inlets. See illustration on reverse side of this page. Make sure the fuel pump filters are clean. Run the engine at full throttle within its operating range until a stable fuel pressure is observed - usually within one minute. Pressure must be between 2-1/2 and 6 psi.
▣ NOTE
Unless engine is broken-in do not run full throttle for more than 1 minute without returning to part throttle for a cooling period.
If the pressure is less than 2-1/2 psi, disconnect the built-in tank and connect the 6 gallon tank (P/N 387410) supplied with the engine and repeat test.
If the pressure is below 2-1/2 psi with the 6 gallon tank, replace fuel pumps (P/N 387470) and repeat test.
If the pressure with 6 gallon tank is above 2-1/2 psi, but lower with the built-in fuel system there is a problem in the boat fuel system.
2. CHECKING & CORRECTING BUILT-IN FUEL SYSTEMS
Use #376156 fuel connector, #173245 primer bulb and no more than 6' of 1/4" I.D. flexible hose #321236 to connect the tank to the engine. These are the same parts included with OMC 6 gallon tank #387410 supplied with engine.
If the tank is located so that more than 6' of line is required, it must be at least 5/16" minimum I.D. between tank and primer bulb. OMC #319719 flexible hose or 3/8" O.D. copper tubing are satisfactory. All fittings must be a minimum of 1/4" I.D. Be sure lines are free of kinks or sharp bends.
(over)
Fuel System #1103
Do not use auxiliary filters other than the tank pickup tube screen.
Do not use OMC primer pump #377381.
If the lines and fittings are correct and the pressure still checks below 2-1/2 psi in systems with an anti-syphon valve, temporarily by-pass the valve with a length of #319719 hose. If this corrects the problem, replace the anti-siphon valve with one of these OMC anti-siphon valves:
P/N 173273 for 5/16" I.D. Hose
P/N 173274 for 3/8" I.D. Hose
P/N 173275 for 3/8" O.D. Copper Tube
P/N 173274 for 3/8" I.D. Hose
P/N 173275 for 3/8" O.D. Copper Tube

EVINRUDE MOTORS
Service Department
Service Department