Evinrude Service Bulletin 1112 - Proper Mounting of 1976 200 HP Outboards

February 1976 safety bulletin warns dealers to install the complete mounting hardware and support plates when rigging 200 HP outboards.

Evinrude Service Bulletin header
ENGINE MOUNTING #1112
February, 1976
PROPER MOUNTING OF 1976 200 H.P. OUTBOARDS

⚠ SAFETY WARNING

It has come to our attention that some dealers are installing 200 H.P. motors on boats without using all the mounting hardware supplied.

In addition to the hexbolts, washers, and nuts, it is essential that the transom mounting plates and support plates be installed in accordance with the installation instructions found in each 200 H.P. owner's manual (Pages 9 and 12). If these plates are not installed and the engine were to strike an underwater object, there is an increased chance of transom bracket breakage resulting in sudden operator loss of control.

200 HP outboard mounting diagram showing flat washers, hex nut, retainer, support plate, mounting plate and hex bolt

Under the Federal Boat Safety Act of 1971, you, the dealer, are defined as a manufacturer when you install equipment and alter boats (as in rigging) and therefore are responsible for proper rigging.

To protect yourself and to assure your customers of the safest possible installation of their motor, install the motor according to the installation instructions, using all the hardware furnished with the motor.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

3/8" Drive Click Torque Wrench (Inch-Pounds) & Blue Threadlocker

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.