
NOTE
I. We have had reports of water leakage into the powerhead and, on occasion, cylinder head gasket blowout. Our testing has shown that this problem can be corrected by increasing the torque on the cylinder head bolts to 18-20 foot pounds from the currently recommended 14-16 foot pounds. This higher torque is being applied to all new 55 H.P. engines built.
As part of your pre-delivery inspection on new engines, you should check the torque and increase it to 18-20 foot pounds (following the tightening sequence shown in Figure 5-43 in your service manual) where necessary. Any 1976 55 H.P. engines brought in for routine service should also have the higher torque applied.
Please make a note of this torque change on page 2-3 of your 1976 55 H.P. service manual.
II. We want to reemphasize to you the need of advising your customers of the importance of faithfully following the break-in instructions as explained in the owner’s manual. This information should be reviewed with the customer at the time of delivery of the engine. It should be pointed out that proper break-in is the best single insurance policy for a long trouble-free engine life.
Service Department