Change in Choke Linkage on 1976 V-4 Models

April 1976 factory instructions for adjusting the revised solid-link choke solenoid on V-4 outboards.

Evinrude service bulletin header
FUEL SYSTEM #1122

April, 1976

CHANGE IN CHOKE LINKAGE ON 1976 V-4 MODELS

We recently changed the choke linkage on our V-4 engines to improve the choke function. A solid solenoid link similar to the type used on the V-6 engines is now being used.

Choke solenoid adjustment is similar to the instructions given on page 3-13 of the V-6 service manual. These instructions with applicable V-4 changes are shown below.

CHOKE SOLENOID ADJUSTMENT

  1. Loosen solenoid clamp screws.
  2. Close choke valves by pushing solenoid plunger into solenoid. If necessary, move solenoid so that choke valves close completely.
  3. With plunger held so that choke valves are still in the closed position, move the solenoid so that plunger is bottomed in solenoid.
  4. While continuing to hold plunger, move solenoid away from plunger (down 1/32") and tighten clamp screws.
  5. Check to make sure that plunger slot does not bind on key in solenoid.

The solid link choke system is used on V-4 engines starting with the following model and serial numbers:

85693   04321
85699   01001
115693  03458
115699  01001
135683  02168
135643  02199

When the choke solenoid was modified recently, the ground and positive leads changed position in relationship to the slot on the solenoid plunger. Therefore, the ground wire should face the front and the positive wire should face the rear so that the wiring can be attached easily. Be sure that the linkage does not bind.

EVINRUDE MOTORS
Service Department