New Cylinder Head Gasket Coating for 9.9 Through 200 H.P. Models

April 1976 Powerhead Bulletin #1125. Factory-coated head gaskets must not receive additional gasket sealer.

Evinrude Service Bulletin
POWERHEAD #1125
April, 1976
NEW CYLINDER HEAD GASKET COATING
FOR 9.9 THROUGH 200 H.P. MODELS
Until now, the outboard service manuals have recommended coating both sides of the head gasket with OMC Gasket Sealing Compound before installation. We recently added a coating to 9.9 through 200 H.P. gaskets which eliminates this requirement thus speeding the installation. Gaskets which have this coating will be stamped “DO NOT USE SEALER” as shown in the illustration.
These new style gaskets are being phased into production and service. When you do start receiving them, it is important that you not use a gasket sealer since it may be incompatible with the factory applied coating.
Cylinder head gasket marked DO NOT USE SEALER
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race & Seal Driver Set + Marine Assembly Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.