Evinrude Service Bulletin #1130

Battery wiring recommendations for electric trolling motors and outboards, including precautions against electrolytic corrosion.

Evinrude Service Bulletin
ELECTRICAL #1130
June, 1976

RECOMMENDED BATTERY HOOK-UP WITH
OUTBOARD AND ELECTRIC OUTBOARD

I.   12 and 24 V Models
We recommend that separate batteries be provided for the electric trolling motor and the primary outboard motor. Using a common battery source for both motors may allow the electric trolling motor to discharge the battery to the point where the primary motor cannot be started.

II.   24 V Models
In those instances where a 24V trolling motor is installed and space cannot be found for separate batteries and one of the batteries is used for both the electric outboard and the primary power source (bearing in mind the potential problems in paragraph I above). Care must be taken to insure that a potential electrolytic condition is not created. Refer to the schematic below for an approved method of connecting to the battery source. Note the following points:

1. The outboard motor should always be connected to the #2 battery as shown.

Recommended 24 volt trolling motor and 12 volt outboard battery connections

2. The trolling motor and the outboard motor should be grounded at the same terminal.

3. If the outboard motor were connected to the positive and negative terminals of the #1 battery, there would be a 12 volt potential difference between the electric motor’s ground and the outboard’s ground. This difference will cause electrolytic corrosion to occur.

EVINRUDE MOTORS
Service Department