Evinrude Bulletin #1152: 35 H.P. Motor Overheating
Factory service information issued in May, 1977. This historical reproduction preserves the bulletin's service instructions.

When a 35 H.P. engine has overheated due to insufficient cooling water reaching the powerhead it is a good idea to remove and inspect the #319577 inner exhaust cover for being warped.
A warped exhaust cover plate can cause exhaust gases to enter the cooling system creating enough pressure to keep cooling water from reaching the powerhead. This results in intermittent or consistent overheating whenever the engine is run.
Inspect the #321513 water tube guide and the #302497 grommet which are located at the front of the inner exhaust tube. Be sure to inspect the plastic spacer #322408 (short) or #322409 (long) above the water pump. Also check the cylinder head for flatness. These parts are subject to distortion when there is a lack of cooling water.
Check the thermostat and replace the cylinder head gasket. Then retorque the cylinder head and cover to specifications in the service manual.
Never run the motor out of water without cooling water from a fresh water flushing kit.
Service Department