Evinrude Service Bulletin #1161: ARMATURE PLATE IMPROVEMENT KIT

September 1977 ignition bulletin describing the armature plate improvement kit for 1973-1976 18, 20 and 25 HP Evinrude outboards.

Evinrude Service Bulletin
IGNITION #1161
September, 1977
ARMATURE PLATE IMPROVEMENT KIT
SUBJECT: ARMATURE PLATE IMPROVEMENT KIT FOR MODELS: 1973-76 18, 20 AND 25 H.P. MOTORS
This kit is now available and contains improved ignition system and cooling system components designed to provide smoother running and reduced spark plug fouling.
The thermostat plug, see Figure, raises the operating temperature for smoother running and reduced plug fouling in cold water.
The armature plate and the armature plate retaining ring and sleeve and associated parts provide smoother running and reduced plug fouling thru better support of the armature plate which provides more consistent breaker point operation.
This kit should be used on motors where the crankcase boss, see Figure, is not worn to less than 1.685 inches (42.8mm).
It is recommended that the ignition coils on 1973 motors be replaced with high output coils, P/N 581786, (not in kit) when using this kit.
Order kit number 388634. These kits are available from your OMC Parts Distributor.
Original Evinrude technical illustration
EVINRUDE MOTORS Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Spark Plugs (Champion/NGK) & Spark Plug Gap Gauge

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 581786

Search for original or compatible replacement part 581786. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.