Evinrude Service Bulletin #1167 - V-4 and V-6 Tilt and Trim Troubleshooting
Issued December 1977, this eight-page factory bulletin provides a quick-reference diagnostic guide, hydraulic flow schematics, current-draw specifications and repair illustrations for V-4 and V-6 power tilt and trim units.
The bulletin covers tilt leakdown, reverse lock faults, slow or inoperative trim, valve and pump troubleshooting, and cylinder removal tools. Original diagrams and dense factory instruction pages are reproduced below.









Factory service data
Figure 5 gives approximate normal current draws: trimming up 23 A, tilting up 27 A, full tilt up 44 A, tilting down 20 A, trimming down 20 A and full trim down 29 A. The bulletin calls for a D-60 DC ammeter and a fully charged 12 V battery for comparison testing.
Figure 6 illustrates a modified bent screwdriver for removing trim-cylinder sleeves; Figure 7 shows Snap-on and Proto spanner wrenches; Figure 8 illustrates a socket-type spanner. No OMC special-tool part numbers are provided for these illustrations.