
ACCESSORIES #1189
May, 1978
INTEGRAL POWER TRIM AND TILT SERVICING
SUBJECT: INTEGRAL POWER TRIM AND TILT SERVICING
The later 1978 production Integral Trim & Tilt Manifold includes a new pump control piston and spring system designed to prevent hydraulic lock-up and lost reverse lock position when trailing motor in tilted position. Manifolds designed to use this new piston can be identified by a “+” symbol on manifold castings under left trim cylinder cavity. The new type piston and springs must be used with this new manifold and cannot be used on manifolds without “+” stamp. To simplify the removal and installation of the Power Trim and Tilt units, we suggest that you use a Drag Link Socket which is available from your Snap-On-Tools Distributor.
The Drag Line Socket (shown above) is P/N A-26 with 1/2” drive. If necessary a Handle Adapter A-2 1/2” to 3/8” can also be purchased from your Snap-On-Tools Distributor.
CR78-32

EVINRUDE MOTORS
Service Department