Evinrude Service Bulletin #1193: 1978 - 140 H.P. IDLE AIR BLEED RESTRICTORS

This June 1978 Evinrude bulletin identifies idle air bleed restrictors for 140 HP outboards and specifies restrictor sizes for early and later carburetors.

Evinrude Service Bulletin
FUEL SYSTEM #1193

June, 1978

SUBJECT: 1978 - 140 H.P. IDLE AIR BLEED RESTRICTORS

We have been informed that some 1978 140 H.P. motors have left the factory minus the Carburetor Idle Air Bleed Restrictors. If you have encountered a new 140 H.P. that either won't idle or is so lean that it has a rough irregular idle, check the carburetors to make sure these Idle Air Bleed Restrictors are in place. They are located in the bottom of the carburetor bodies, as shown in Figure 1.

For the first production 140's with carburetors numbered 388864 and 388865, the idle air bleed restrictor is 318494 (.036). For later carburetors 389785 and 389784 the idle air bleed restrictor is 318073 (.025).

Evinrude 140 HP carburetor idle air bleed restrictor locations
CR78-34