Evinrude Service Bulletin #1206 - New Hot Horn
October 1978. This factory bulletin introduces a plastic replacement hot horn for 1973 through 1978 standard remote controls and explains a wiring correction to prevent the horn lead from shorting against the control housing.

SUBJECT: NEW HOT HORN
MODELS: 1973 THROUGH 1978 STANDARD REMOTE CONTROL

The plastic construction should make this horn less vulnerable to corrosion in a salt water environment and extend its useful life.
Due to printing schedules, the part number for the new horn does not appear in any 1978 parts books. Since it does offer an improvement in overall performance, it is desirable that this new horn be used whenever replacement is required.
The new horn will replace the old metal horn and associated parts in all remote control assemblies from 1973 to the present 1978 model.
Please mark all your parts books for 1973 through 1978 with remote controls to indicate the following changes:
317930 not required with 388910
323334 not required with 388910
TRIM & TILT ENGINES
We have heard of several cases of the hot horn, where the purple lead from the key switch has shorted against the remote control box (casting). Most cases have occurred on engines that have the trim gauge lead or accessory tachometer lead attached to the purple wire using adapter P/N 319984. This may short circuit the 20 amp fuse in the engine wiring harness.
To eliminate this condition, change the original position of the purple wire to the terminal to tan wire terminal and put the tan wire on the terminal where the purple wire was previously attached. This procedure must be followed when new hot horn P/N 388910 is used to replace the old horn P/N 279336.

Service Department