Evinrude Service Bulletin #1212 - Armature Plate and Pilot Replacement Kit
Issued January 1979, this ignition service bulletin describes repair kit P/N 389813 for worn armature pilot diameters on 1974-1976 9.9 and 15 HP and 1976 35 HP Evinrude outboards. It explains when the repair kit can avoid cylinder and crankcase replacement.

SUBJECT: ARMATURE PLATE AND PILOT REPLACEMENT KIT P/N 389813
MODELS: 1974 - 1976 9.9 & 15 H.P. and 1976 35 H.P.
When complaints of spark plug fouling or excessive movement of the armature plate lead to the discovery of a worn armature pilot diameter on the cylinder block, it is not necessary to replace the cylinder and crankcase assembly on powerhead. See Figure 1.
Installation of the Kit P/N 389813 will eliminate the breaker point fluctuation which caused the spark plug fouling. Use this kit only if there is wear at the pilot bearing since there are a number of other causes of spark plug fouling such as weak ignition, scored cylinders, too heavy oil to gas ratio, use of poor quality oil, overpropping (too large pitch for boat and average load carried), engine sitting too deep in water, wrong spark plugs, etc.
The new armature plate and pilot replacement Kit P/N 389813 (Figure 2) is now available at a special net price (no discount). Installation of this kit is considered a maintenance item not normally eligible for warranty consideration. It will save the customer the higher cost of a cylinder and crankcase or powerhead along with their higher installation costs.

Service Department