Evinrude Service Bulletin #1218: Carburetor Improvements - 1979 175 HP
March 1979 fuel-system bulletin detailing revised idle air bleeds for 1979 175 HP outboards.

SUBJECT: CARBURETOR IMPROVEMENTS
MODELS: 1979 175 H.P.
Mid year changes to the 175 H.P. carburetors have improved the low speed idle performance with a change to the idle air bleeds. Carburetors with these improvements have the letter “E” stamped on the carburetor body.
Engines with serial numbers prior to these changes are:
| JOHNSON | FIRST SERIAL NUMBERS WITH NEW IDLE ORIFICES |
|---|---|
| Model 175TL79 | 05168567 |
| Model 175TXL79 | 05169865 |
| EVINRUDE | |
| Model 175949 | 01155 |
| Model 175940 | 01107 |
Engines with serial numbers prior to these numbers which show indications of lean idle which cannot be corrected with proper throttle synchronization should have the following:
New idle air bleeds should be installed in the carburetor castings following these instructions:
- Remove the carburetors from the engine and remove the carburetor float bowls.
- Using a 1/8” diameter flat end punch, drive the two idle air bleeds into the body an additional 3/16”. See Figure 1.
- Using the same punch, install new idle air bleeds, P/N 318494, supplied by your Service Department.
- Reinstall the carburetor float bowls and carburetors to the engine. Connect carburetor linkage and synchronize the carburetors as shown in your Service Manual.

For this work file a warranty claim with engine model and serial number requiring new idle air bleeds and six new idle air bleeds, P/N 318494, will be returned along with payment for two hour’s labor for their replacement and test time.
Service Department