Evinrude Service Bulletin #1221: 25-35 NEUTRAL START SWITCH MOUNTING NUTS

Issued April, 1979, this factory bulletin addresses 25-35 neutral start switch mounting nuts.

Evinrude Service Bulletin header
POWERHEAD #1221

April, 1979

25-35 NEUTRAL START SWITCH MOUNTING NUTS

In the event of the two square Neutral Start Switch mounting nuts on 25-35 models vibrating loose, correct by the following procedure. Clean mounting screws and nuts with OMC Loctite Primer (Part No. 384884) and then install, using OMC Nut Lock (Part No. 384849) and torque mounting screws to 7-10 in. lbs. (0.8 - 1.2 N·m). There is also a locknut available (Part No. 325994) which can be used as a replacement.

If it is necessary to adjust the neutral start switch, proceed as follows:

Put shift handle in neutral position. Using a continuity light, turn shifter lock switch adjustment screw in towards switch until the light has just come on. Turn the screw an additional 1-1/2 turns toward the switch. Lock the screw with the locknut.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter & Marine Electrical Connector Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 384884

Search for original or compatible replacement part 384884. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.