
SUBJECT: SHIMMING PINION GEAR
MODELS: 1979 55 H.P. STANDARD & LONG
Premature pinion gear failure has been reported that upon investigation resulted from over-shimming the pinion gear. A change in shimming specifications on 1979 gearcases has been developed to eliminate this problem and two new service driveshaft assemblies have been released to accommodate this procedure.
The 1979 Preliminary Edition Parts Catalog has listed P/N 389757 Driveshaft for Standard Models and P/N 389758 Driveshaft for Long Models. These driveshafts have been superseded by Driveshaft P/N 391161 - Standard and Driveshaft P/N 391162 - Long.
When shimming the pinion gear on any driveshaft for 1979 and later models using Shim Gauge P/N 320739, follow the service procedure as outlined in your Service Manual and subtract .007” shims from total shims called for and reassemble minus .007 shims. See Figure 1.
Gearcases that have been corrected at the factory to the minus .007” shims on pinion gear are identified by a stamped number “7” on the rear of the gearcase as shown in Figure 2.
Any gearcases which require a new driveshaft, pinion gear forward gear should be shimmed to this minus .007” shims and stamped with a Number 7, as shown in Figure 2. Existing gearcases that do not require new gears or driveshaft should not be disassembled for the removal of .007” shims.
If you have driveshafts P/N 389757 or P/N 389758 and you cannot remove the .007 shims as described, return these to your Distributor for credit and order P/N 391161 or P/N 391162 for use on 1979 and later gearcases.

