Evinrude Service Bulletin #1227: Integral TNT Replacement Relief Valve O-Ring

Issued July, 1979. Integral trim and tilt units. This archival reproduction retains the factory service guidance and illustration.

Evinrude Service Bulletin factory header
ACCESSORIES #1227
July, 1979

SUBJECT: INTEGRAL TNT REPLACEMENT RELIEF VALVE O-RING

In the event of either an inoperative Trim & Tilt unit or one that trims up slow or only trims up part way, check for a worn or frayed relief valve o-ring. (See Figure 1.) This o-ring has been superseded by a new one (P/N 326425) which is more resistant to wear. We recommend that this o-ring be replaced as a preventative measure when servicing these trim units.

Factory Figure 1 - Integral TNT Replacement Relief Valve O-Ring
EVINRUDE MOTORS
Service Department
CR 79-37

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim & Tilt Hydraulic Fluid & Spanner Wrench

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 326425

Search for original or compatible replacement part 326425. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.