Evinrude Service Bulletin #1233 (August 1979)

This powerhead bulletin addresses overheating in certain 1979 4 HP Johnson and Evinrude outboards caused by machining chips obstructing cylinder water passages. It lists affected serial numbers and describes inspection, cleaning, and enlarging the water discharge passage.

Evinrude Service Bulletin header
POWERHEAD #1233
August, 1979

SUBJECT: OVERHEATING DUE TO BLOCKAGES OF CYLINDER WATER PASSAGES

MODELS: 1979 4 H.P.

Field incidents reported to us indicate that there are some 4 H.P. engines that may overheat due to machining chips in the cylinder water passages causing inadequate water flow.

Engines not yet sold and those already sold to customers should be inspected to determine if there are machining chips present in the cylinder water passage which could cause blockage of the water flow and overheat the engine.

To increase water flow and prevent restrictions in the cylinder water passages, the discharge passage should be increased to 3/16” by drilling out the 1/8” hole to the cylinder head.

Engines where this situation may exist which should be redrilled to 3/16” include the following engines:

ModelSerial Numbers
Johnson Models4R795033401 thru 5034751
4RL795035301 thru 5035517
4W795031401 thru 5033110
Evinrude Models4904E01001 thru 02920
4932E01001 thru 01980
4933E01001 thru E01250

Use the following procedure to inspect and clean the cylinder water passages and drill out the outlet hole to 3/16”. File a standard warranty claim form for 1 hour (1.0) labor and gasket, P/N 323445 and Head Gasket P/N 203130.

  1. Remove fuel tank filler cap and drain fuel from tank.
  2. Remove choke knob screw and choke knob.
  3. Remove low speed idle knob.
  4. Loosen front and rear motor cover screws and remove lower motor cover.
  5. Remove four screws holding top motor cover and starter housing. Remove cover.
  6. Disconnect plastic fuel clamp at fuel filter.
Original bulletin page 2 with steps 7 through 20, technical photographs and torque specifications

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires & Rebuild Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 323445

Search for original or compatible replacement part 323445. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.