Evinrude Service Bulletin #1236: Commercial Use Of Larger Outboard Motors

Updated commercial-duty recommendations and low-compression cylinder head kit part numbers, replacing Bulletin 1231.

Evinrude Service Bulletin header
ACCESSORIES #1236

October, 1979

SUBJECT: COMMERCIAL USE OF LARGER OUTBOARD MOTORS

MODELS: 1977 AND LATER 70/75 H.P., V-4, V-6

PLEASE DISCARD ORIGINAL BULLETIN #1231 AND REPLACE WITH THIS UPDATED VERSION

Commercial operators using our larger outboard motors and wishing to extend the useful service life of these motors, may be helped by the following:

1. On 1977 and later motors, install the respective low compression cylinder head kit. These kits will lower the compression pressures and temperature with some associated loss in performance.

MODELKIT PART NUMBER
1974-1978 70 H.P. & 75 H.P.387071
1979 70 H.P.390907
1979 75 H.P.390908
1977 & 1978 85 H.P.389490
1979 & later 85 H.P.389187
1977 & later 115 H.P. & 140 H.P.389187
All V-6 except 1980 235 H.P.389489

2. Select a propeller for these applications that enables the motor to run in about the middle of the recommended R.P.M. range at full throttle. This provides the best compromise for fuel economy, durability and performance, especially in commercial use.

The above two steps should be used in conjunction with the lubricant and fuel recommended or specified in the Owner’s Manual.

The use of Evinrude 50/1 lubricant, or equivalent BIA TC-W certified lubricant, which is formulated to give best engine performance with least combustion chamber deposits, least piston varnish, maximum spark plug life and best lubrication, is critical in providing good engine life. This should especially be stressed to all commercial operators.

CR 78-66   © OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED

Related factory bulletin: Evinrude Bulletin #1231 (superseded by #1236).