Evinrude Accessories Bulletin #1248: OMC Tachometers

Issued March 1980, this bulletin explains five-pulse and six-pulse tachometer compatibility, plug-in connector installation, and tachometer mounting precautions.

Evinrude Service Bulletin header
ACCESSORIES #1248

March, 1980
Subject: OMC Tachometers

We have received reports of incorrect applications of some OMC Tachometers where a six-pulse tachometer has been used on a motor that required a five-pulse tachometer. This results in an incorrect reading with the tachometer reading less than actual engine R.P.M. Five-pulse tachometers, P/N 173492 and P/N 173493, are used only on motors with the five amp alternator. All other OMC tachometers are used on motors with either 6, 9, 10, 12 or 15 amp alternators. The following applications chart should be helpful.

(5-pulse) Tachometers P/N 173492 and P/N 173493

6 H.P. 1977 thru (when equipped with 5 amp alt. kit)
9.9/15 H.P. 1977 thru (when equipped with 5 amp alt.)
25/35 H.P. 1977 thru (when equipped with 5 amp alt.)
50/55/60 H.P. 1978 thru (when equipped with 5 amp alt.).

(6-pulse) OMC Universal Tachometers

50 H.P. thru 235 H.P. 1968 and later
(with the exception of models listed above with 5 amp alt.)

It should be noted that the 5-pulse tachometers, P/N 173492 and 173493, are not equipped with the plug-in connections to fit the 1979 and later control boxes. The plug-in adaptors are available separately under P/N 173602 or 173611. See your OMC Accessories Catalog.

A high percentage of plug-in tachometers returned for warranty are found to be in good working condition. Improper operation of a plug-in tachometer has been found to be a result of improper connection of the plug-in connectors. Before connecting the plugs, coat the barrel of the male plug with a thin coat of OMC Triple-Guard Grease. See Figure 1. Do not get any grease on the pins as they may be pushed out when connecting the plugs. Plug connectors together until female is all the way to base of male. See Figure 2.

Figure 1: male and female connector and grease locationFigure 2: female connector seated to base
CR 79-87 Rev. 1   © OUTBOARD MARINE CORPORATION 1980 ALL RIGHTS RESERVED

A few OMC Tachometers returned for warranty were found to have the meter movement rear bearing crushed. This is caused by someone removing the mounting stud from the rear of the tachometer and either putting it in backwards or using an improper stud in its place. The stud hole in these cases is open to this rear bearing and damage to the bearing results in a “sticky” tachometer or one that is completely inoperative. The mounting stud must be removed when using an OMC Pod Mount Instrument Kit (#172361) and therefore the installation instructions in this kit should be followed exactly when installing one to ensure that the proper mounting screw in the kit is utilized for the particular tachometer being installed.

EVINRUDE MOTORS
Service Department

Parts referenced

Five-pulse tachometers: 173492, 173493. Plug-in adapters: 173602, 173611. OMC Pod Mount Instrument Kit: 172361.