Evinrude Service Bulletin #1259
Explains missing adapter-plate cooling passages on certain 1979 V-6 models and associated loss of maximum RPM.

Subject: Adapter Plate P/N 322313 - Loss of Maximum RPM
Models: 1979 150, 175, 200 V-6 Outboards
There are indications that a cooling passage hole was missing on an undetermined number of adapter plates, P/N 322313, for 1979 150, 175 and 200 HP models. This hole is used to apply water to the tuning megaphone to reduce the likelihood of its burning through and a resultant power loss.
The adapter plates were all made correctly after the following serial numbers and cartons stamped with the letter “J”.
Evinrude Models:
150949 04542
150940 01292
175949 02501
175940 01449
200949 02009
200940 01427
In some cases it may be difficult to detect any loss in performance when the megaphone has been damaged, making this condition hard to diagnose. You will usually experience a loss of approximately 200-500 RPM at wide open throttle. The condition of the megaphone can be determined by removing the gearcase and looking up into the inner exhaust housing. If the megaphone is burned or damaged, it would be an indication that there is no cooling passage hole in the adapter plate and the adapter plate and megaphone must be replaced. We suggest that you inspect as many of these V-6 models as possible in the course of normal maintenance, and any replacement adapter plates you may have on hand. The location of this cooling hole is shown in Figure 1.
