Evinrude Tools Bulletin #1260 (May 1980)

This bulletin describes a modification to the OMC Power Tilt & Trim Test Stand, P/N 390008, to allow access to the manual release valve during bench testing of V-4 and V-6 tilt-and-trim units. The second factory page provides the cutting template.

Evinrude Service Bulletin header
TOOLS #1260

May, 1980
Subject:  Modification for Special Tool
            Power Tilt & Trim Stand P/N 390008

Models:  V-4 & V-6 Tilt & Trim

It has been recommended that a slight modification to the new Power Tilt and Trim Test Stand, P/N 390008 can allow bench testing of the unit after repairs using the Tilt & Trim Pressure Tester Gauges, P/N 390010.

Access to the manual release valve can be provided by cutting one side of the stand with a hacksaw as shown in Figure 1. The template on the reverse side will serve as a guide for marking the portion of the stand to remove.

Figure 1, tilt and trim stand showing modified side
Figure 1
EVINRUDE MOTORS
Service Department
Original full-page cutting template showing Cut on Line and hatched Remove section

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Outboard Tachometer / Boat Dash Gauge

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 390008

Search for original or compatible replacement part 390008. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.