Johnson Service Bulletin SB-1232 (January 1970)

Factory adjustment procedure for improved low-speed running on Johnson 60 HP outboards, including throttle cam alignment, spark advance and carburetor settings.

Johnson Motors Service Bulletin letterhead
SB-#1232
January, 1970
SUBJECT: SETTING OF 60 H.P. TO SECURE IMPROVED LOW SPEED RUNNING
Our Engineering Department has advised that the 60 horsepower low speed running characteristics can be improved by properly adjusting the spark throttle relation and by setting the low speed needle valves to a fixed position "off the seat."
Make adjustments as follows:
Factory Figures 1 and 2: throttle cam and low tension distributor lead connector
1. Adjust carburetor linkage so that all throttle valves will close. 2. Adjust throttle cam follower so that mark on throttle cam will align with center of cam follower roller just as roller makes contact with cam. 3. Make a new mark 9/32" up along edge of throttle cam from center of cast mark at edge of throttle cam. Scribe a line perpendic- ular to edge of cam at that point as shown in Figure 1. 4. Disconnect spark plug leads at spark plug. Disconnect low tension distributor lead connector located to the rear of the throttle cam as shown in Figure 2. Connect a circuit tester between ground and distributor lead connector. (Connector takes a 1/4" spade terminal.)
(over)
PAGE 2 SERVICE BULLETIN SB-#1232 JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
5. Turn flywheel so that timing mark "A" on higher rim of flywheel is directly in line with center of crankshaft and 22° mark on ring gear guard. 6. Move armature plate to full advance against rubber bumper on adjustment screw. Adjust spark advance adjustment screw so that points just make and break, as indicated by circuit tester, when armature plate is at full advance and flywheel is at 22°. 7. With armature plate at 22° advance, adjust yoke on link at throttle cam so that scribe mark on cam will align with center of cam follower roller within 1/32 of an inch. 8. Remove circuit tester, reconnect distributor lead connector and reconnect spark plug leads. Adjust carburetor low speed needle valves 11/16 of a turn off seat. 9. Run engine on boat and make adjustments where necessary; such as, idle adjustment screw and low speed adjusting knob.
JOHNSON MOTORS Doug Cankar Administrative Assistant
DC:rm NOTE: Post on your 60 H.P. Index under the heading "Carburetor."