Johnson Service Bulletin SB-1238 - Installing Converging Ring

Issued April 1970, this bulletin explains the installation of replacement converging rings on aluminum through-hub propellers for 55 through 115 H.P. outboards, including the press-fit and staking procedure.

Johnson Motors Service Bulletin letterhead
SB-#1238
April, 1970
SUBJECT:   INSTALLING CONVERGING RING
ON MODELS:  All 55 thru 115 H.P. With Aluminum Thru Hub Propellers
Figure 1: propeller in arbor press for converging ring installation
We now have available, for service,
the converging ring for aluminum
thru hub propellers. Installation
of the converging ring is easy but
it does require an arbor press and
pressing plate. See Figure 1. Do
not attempt to install the conver-
ging ring with a hammer since it
might become cocked and damaged.
There are six ribs on the inner
diameter of the converging ring.
When the ring is installed, these ribs cause a press fit on the pro-
peller. The propeller being serviced will probably have six grooves
or marks from the old converging ring. When installing the new ring,
do not align the ring ribs with these grooves.
After the ring has been pressed on, it should be staked at every
other converging ring rib. See Figure 2.
PAGE 2          SERVICE BULLETIN   SB-#1238
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
The converging ring is stocked
under part #314188 and has a list
price of $1.20 with standard dis-
count. Order from your Parts
Distributor.
Figure 2: staking the converging ring on a propeller
FIGURE 2
JOHNSON MOTORS
Doug Cankar
Administrative Assistant
DC:rm
NOTE:  Post on your 55 through 115 horsepower Indexes under the
       heading "Miscellaneous."
FOOTNOTE:  In SB-#1200 we informed our dealer organization not to
          use the test tank water adapters, commonly referred to
          as flushettes, when running the subject engines out of
          water for cooling purposes. The Tempo Flushette is ok
          to use on the 1970 models with through the prop hub
          exhaust.

Historical notes

Factory part number 314188 was listed at $1.20 in April 1970. The second page also clarifies guidance from SB-1200 concerning use of the Tempo Flushette on 1970 through-hub exhaust models.

1970-1980 Johnson Service Bulletin Index

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Wrench & Marine Spline / Triple-Guard Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 314188

Search for original or compatible replacement part 314188. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.