Johnson Service Bulletin SB-1243 - Overheating of Propeller Hubs

Issued in August 1970, this bulletin explains the revised trim tab and cooling-water passage for 85 and 115 H.P. outboards used on slow-moving boats.

Johnson Motors Service Bulletin letterhead
SB-#1243
August, 1970
SUBJECT: OVERHEATING OF PROPELLER HUBS
ON MODELS: 85 and 115 H.P.
Figure 1: revised trim tab with cast letter L
FIGURE 1
We recently released a new trim tab for the subject models. This trim tab (P/N 316981) has a water pick-up hole which pro- vides additional cooling of the propeller hub on slow moving boats such as house boats. We recommend that you install this new trim tab on any 85 or 115 H.P. engine used on slow moving boats.
NOTE (85 H.P. engines built after Serial #333557 and 115 H.P. engines built after Serial #3344891 already have the new trim tab.)
Figure 2: drilling the water passage through the gearcase
FIGURE 2
All 85 and 115 gearcases require drilling except those with the cast letter "F" on the port side of the gearcase just above the anti-cavi- tation plate, or the letter "L" stamped above the trim tab on the gearcase. (See Figure 1) Use a 3/16" diameter long series (5-3/4") bit to drill the water passage.
JOHNSON MOTORS Doug Cankar Technical Data Coordinator
DC:rm
NOTE: Post on your 85 & 115 H.P. Indexes under the heading "Lower Unit".