Johnson Service Bulletin SB-1257 - Driveshaft Breakage

This 1971 bulletin describes a driveshaft keyway alignment procedure for 40 H.P. outboards, production serial-number thresholds, and an operating-speed warning.

Johnson Motors Service Bulletin letterhead
SB-#1257

SUBJECT: DRIVESHAFT BREAKAGE

ON MODELS: 40R(L)71, 40E(L)71- 40 H.P.

A change has recently been processed to minimize driveshaft breakage on the 1971, 40 H.P. engines.

A very easy procedure for making this change is as follows:

Step 1 - Align the #1 piston to top dead center. The easiest way to accomplish this would be to remove the #1 plug and insert a screw driver or some other tool to assure top dead center.

Step 2 - With the gearcase removed from the engine, loosen and lift the water pump housing so that one can view the water pump keyway, and rotate the driveshaft so that the water pump keyway is facing the rear of the engine.

Step 3 - Then, mark the driveshaft directly above the water pump housing using a felt tip pen or some other marking instrument. This mark should correspond to the keyway on the driveshaft. By marking the driveshaft, you will be able to tell where the keyway is when the water pump housing is assembled.

Step 4 - After re-installing the water pump housing, check once more to see that the driveshaft keyway is still facing the rear of the engine.

Step 5 - The gearcase may now be re-assembled to the engine.

The engine should also be propped so that it does not run in the 4100 ± 200 rpm range. This is very important, especially if used in a commercial operation where this rpm range is maintained for extended periods of time.

(over)

PAGE 2SERVICE BULLETIN
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

This change should be done prior to sending out new 1971, 40 H.P. engines, if the serial numbers are prior to:

40R71B--------------------J3446714 40RL71B-------------------J3451079 40E71B--------------------J3453433 40EL71B-------------------J3456904

If you should happen to get a 40 H.P. engine into your shop for service, prior to 1971, 40 H.P. models, we recommend that this change be incorporated.

JOHNSON MOTORS

Doug Cankar
Technical Data Coordinator

DC:sn

Post on your 40 H.P. indexes under the heading "Lower Unit".