SB-1267 - Overheating

Issued in July 1971, this Johnson service bulletin warns that a water pump impeller can overheat an engine if the rubber separates from its hub. It describes a simple bonding inspection and references an earlier overheating bulletin.

Johnson Motors Service Bulletin letterhead
SB-#1267
July, 1971
SUBJECT:   OVERHEATING
ON MODELS:   All Models
Factory photograph showing separation of the water pump impeller rubber from the hub

If evidence of overheating has been encountered the water pump and impeller should be the first thing to look at as a possible cause of this difficulty.

We strongly recommend that before installing a water pump and impeller, you check to make sure the bonding to the hub of the impeller is good. The impellers can be easily checked to see if they are good or bad by using the seal installer part number 308103 as shown on page 22 of your special service tool catalog or a similar object.

When performing this check, lay the wide end of the seal installer on a table, take the impeller and insert it over the seal installer and apply downward pressure on the fingers of the impeller (see illustration) checking to see that the bonding to the hub of the impeller is good. There should be no separation between the impeller and the hub.

Because a defective impeller can seriously reduce the flow of water to the engine, we urge you to inspect your inventory of impellers immediately.

For further information concerning overheating, refer to service bulletin #1103 and the service manual pertaining to the engine.

JOHNSON MOTORS

Doug Cankar
Technical Data Coordinator

DC/sn
NOTE:  Post on all indexes under the heading "Lower Unit".