Johnson Service Bulletin SB-1273 (September 1971) - Flywheel Nut Torque Change

Johnson increased the recommended flywheel nut torque for 50-125 HP outboards to 100-105 foot-pounds. This bulletin lists the affected models and production serial numbers and explains the checks required before retorquing.

Johnson Motors Service Bulletin factory letterhead
SB-#1273
September, 1971
SUBJECT: Flywheel nut torque change
ON MODELS: 1971-72 50 H.P.; 1968-72 55, 60, 65 H.P.; 1969-72
85, 100, 115, 125 H.P.
We have increased the torque recommendation on all 50 through 125 H.P.
flywheel nuts. The new recommendation is 100-105 foot pounds instead
of the previous 70-85 foot pounds. Please check the flywheel nut on
all new engines before delivery and on any engines which come into
your shop. All engines built after the serial numbers listed below
have been torqued to the new specification:
50ESL72 - 3632467
50ES72 - 3637305
65ESL72 - 3656599
65ES72 - 3660575
85ESL72 - 3677834
100ESL72- 3681888
125ESL72- 3688161
Before retorquing the flywheel nuts, you should first remove the
flywheel, clean the crankshaft taper of any oil or contamination,
and check the key to be sure it is not partially sheared.
All 1972 manual start 50 H.P. motors will be torqued to the new
specifications.
JOHNSON MOTORS
Doug Cankar
Technical Data Coordinator
DC/sn
NOTE: Post on your 50 through 125 H.P. index under the heading
"Ignition".

Historical service reference

The 100-105 ft-lb torque specification replaces the previous 70-85 ft-lb recommendation for the models identified in this September 1971 bulletin. Follow the applicable factory service manual for any later revisions.