Back to previous page

SB-1274 - Service Information on Hydroelectric Gearcases

Issued October 1971, this Johnson Service Bulletin explains the replacement hydroelectric gearcase oil pump, a revised reverse gear for 55-60 H.P. models, and the clearance between the propeller shaft and reverse gear. Both factory illustrations and the original parts comparison are reproduced below.

Johnson Motors Service Bulletin header
SB-#1274
October, 1971
SUBJECT: Service Information on Hydroelectric Gearcases
ON MODELS: All Engines with Hydroelectric Gearcases
For the 1971 hydroelectric shifting models we came out with a new oil pump part number 385056. This new pump supersedes part number 383537 which was used in the earlier hydroelectric gearcases. When replacing a oil pump part number 383537 with the newer oil pump part number 385056 you cannot reinstall the forward snap ring. The forward gear thrust bearing will keep the pump in place, even though it is a smaller diameter bearing than the 1971 forward thrust bearing.
NEW STYLE REVERSE GEAR 55-60 HP MODELS A change has been made to the reverse gear that has caused some concern among dealers as to interchangeability. The following indi- cates the reverse gear installed as original equipment when produced:
OLD STYLE REVERSE
GEAR W/BUSHING
ORIGINAL EQUIP.
ON MODEL
NEW STYLE
REVERSE GEAR
ORIGINAL EQUIP.
ON MODEL
3823091968-1969 55HP
1970 60 HP
3165221971 60 HP
The original old style gears had a bushing. These gears are no longer available and have been superseded by the new style reverse gear. (See Figure 1).
Figure 1: old style reverse gear with bushing and new style reverse gear without bushing
(over)
PAGE 2 SERVICE BULLETIN SB-#1274 JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
The reverse gear pilots on the outside surface which is held in place by the Bearing Housing and Seal Assembly. (See Figure 2 "A"). The inside diameter simply facilitates the passage of the propeller shaft through the gear without directly contacting the shaft. Note the considerable clearance between propeller shaft outside diameter and the reverse gear inside diameter. (See Figure 2 "B").
Figure 2: propeller shaft, bearing housing and seal, reverse gear, clearance positions A and B
JOHNSON MOTORS Doug Cankar Technical Data Coordinator
DC/sn NOTE: Post on your 50 through 125 H.P. under the heading "Lower Unit".

Hydroelectric gearcase service reference

SB-1274 identifies oil pump 385056 as the replacement for 383537 and cautions that the original forward snap ring cannot be reinstalled with the newer pump. The bulletin also compares old reverse gear 382309, which uses a bushing, with replacement gear 316522, and explains the clearance shown in Figure 2.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Hub Kit & Prop Nut Wrench

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 385056

Search for original or compatible replacement part 385056. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.