Back to previous page

SB-1278 - SST Propellers

Issued December 1971, Johnson Service Bulletin SB-1278 explains the expected performance of OMC Accessories SST propellers, including possible RPM changes, transom height, engine tilt, and propeller pitch.

Johnson Motors Service Bulletin factory letterhead
SB-#1278
December, 1971
SUBJECT: SST Propellers
Field reports have indicated there may be some confusion in the field in regard to the application of the OMC Accessories SST Propeller and what can be expected to improve performance with the installation of an SST against that of a standard aluminum propeller. The following are several questions which we have received quite frequently. It is hoped that the answers given will clarify questions you may have concerning SST Propellers. 1. Will RPM drop with the installation of an SST? Answer - In some cases, an RPM drop of as much as 150 RPM's may occur. Should an RPM loss be experienced, it can usually be regained by raising the engine one notch on the transom and/or increasing the tilt pin angle. 2. What affect will raising the engine on the transom have with an SST cupped Propeller? Answer - Raising the engine may increase boat speed. Increased speed may also be attained by changing the tilt angle on the engine itself. A cupped SST Propeller experiences substantially less ventilation, and, therefore, the engine can be run tilted out beyond the point a normal aluminum propeller can be run. 3. Is it necessary to change the pitch on a propeller when going from a standard aluminum to a cupped SST Propeller? Answer - It should not be necessary to change the propeller pitch when going from a standard aluminum to a cupped SST. Additional performance can be gained by changing the tilt angle on the engine. However, if no change in tilt angle or transom height can be made because of boat design, order the next lower pitch propeller. Should you have any questions regarding the application of any SST Propeller, you are invited to write OMC Accessories at the following address. Every effort will be made to answer your question through help of our Propeller Engineering Depart- ment. Please address any inquiry to OMC Parts & Accessories, Galesburg, Illinois, 61401, Attention: Service Department.
JOHNSON MOTORS Doug Cankar Technical Data Coordinator
NOTE: Post on your Miscellaneous Index under the heading "Accessories".
DC/sn

SST propeller performance questions

Johnson addressed three common questions about the OMC Accessories SST cupped propeller: an RPM reduction of up to 150 RPM, possible speed gains from engine mounting height and tilt, and when a lower-pitch propeller may be appropriate. The original factory Q&A above is reproduced as searchable text.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Wrench & Marine Spline / Triple-Guard Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.