SB-1279 - Service Information

Issued in January 1972, this Johnson bulletin explains power-pack terminal and gasket inspection on 50 and 65 H.P. Magneto C.D. ignition engines, and identifies a spark plug boot design change affecting 1972 outboards.

Johnson Motors Service Bulletin letterhead
SB-#1279
January, 1972
SUBJECT: Service Information
SUBJECT I: Ignition system Trouble Shooting ON MODELS: 50, 65 H.P. with Magneto C.D. Ignition
When servicing the ignition system on any of the above models, you should always remove the cover from the power pack and inspect the terminals. If any terminals are sticking up, press them down so they cannot touch the gasket when the cover is installed. Check the cover gasket for wear from terminals. If gasket is worn, replace it. Cement the gasket to the cover using Marprox Sealer 1000.
SUBJECT II: New Spark Plug Boot ON MODELS: All 1972 Outboards
All of the 1972 and some of the 1971 engines have a new longer spark plug boot. If this new boot is not pressed securely on the spark plug there may be a gap between the plug and the inside of the boot. This gap could allow arcing to occur which will cause deterioration.
Factory comparison of old-style and new-style spark plug boots, showing approximately 5/16 inch difference
JOHNSON MOTORS,
Doug Cankar Technical Data Coordinator
NOTE: Post on all indexes under the heading "Miscellaneous".
DC/sn