Johnson Service Bulletin SB-1284 - Supplement to SB-1282 on Service Information

Issued in February 1972, this supplement corrects the drilling instructions in Step 7 of SB-1282 for Johnson 20 and 25 H.P. engines.

Johnson Motors Service Bulletin letterhead
SB-#1284

February, 1972

SUBJECT: Supplement to SB-#1282 on Service Information

ON MODELS: 20 and 25 H.P.

Please make the following corrections in the first paragraph of
Step 7 of SB-#1282 as underlined:

7. DRILLING THE EXHAUST HOUSING

Drill two 3/8" holes in the exhaust housing to relieve back
pressure as shown in the line drawing. Center bottom hole
3/8" up from the arrow point. Drill the holes on a 30°
angle 1/2" center to center. The angle of the holes and
the location of the holes is important to avoid drilling
out the inner exhaust tube locating boss.

Because the location of the holes is important, make sure you
measure 3/8" up from the lip as pointed out by the arrow in the
picture below.

Factory exhaust housing photograph showing arrow marking measurement point

JOHNSON MOTORS

Doug Cankar

Technical Data Coordinator

NOTE: Post on your
20 & 25 H.P. Indexes
under the heading
"Miscellaneous".

Historical notes and references

SB-1284 supplements Step 7 of SB-1282. The original photograph is retained to show the factory's measurement reference; the drilling dimensions above are searchable text.

1970-1980 Johnson Service Bulletin Index