Johnson Service Bulletin SB-1300 (July 1972) - Use of Test Tank Adaptors

Johnson's July 1972 instructions for safely operating through-hub-exhaust outboards with supplemental cooling adaptors, including operating limits and test-tank requirements.

Johnson Motors Service Bulletin letterhead
SB-#1300

July, 1972

SUBJECT: Use of Test Tank Adaptors

ON MODELS: All with Thru Hub Exhaust

When operating an engine using a supplemental cooling adaptor
(sometimes referred to as a flushette) as the only source of
cooling water, the engine may be operated for up to five minutes
at engine speeds below 2000 R.P.M. under no load condition in
neutral. If the engine is operated at greater speeds or for a
longer time, damage to the propeller shaft bearings and seals or
to the propeller hub will result.

If extended running or high R.P.M. is necessary, the engine must
be run in a test tank (in forward only) using the cooling adaptor
as a source of additional cooling water. The engine should also
be equipped with the recommended test wheel.

JOHNSON MOTORS
Doug Cankar
Doug Cankar
Technical Data Coordinator
DC/sn
NOTE: Post on your 50 thru 125 HP under the heading "Lower Unit".
Historical service note: This bulletin distinguishes short no-load operation using an adaptor as the sole cooling source from longer or higher-RPM operation in a test tank with a test wheel.