SB-1303 - Replacing Stern Bracket Clamps

Issued in August 1972, this Johnson Service Bulletin advises dealers to replace worn stern bracket clamps when installing replacement outboards and describes additional transom mounting hardware for 50 and 65 H.P. applications.

Johnson Service Bulletin factory letterhead
SB-#1303
August, 1972
SUBJECT: Replacing Stern Bracket Clamps
Small factory rectangular illustration
ON MODELS: Current Models
It has been called to our attention that some dealers are frequently installing new 65 H.P. thru 125 H.P. motors without changing the worn stern bracket clamps previously used for an older model motor. An example is; a dealer will install a 125 H.P. motor in place of an older 75 H.P. motor without changing the worn transom clamps.
We recommend that you always replace the stern bracket clamps when installing a new motor on a used boat.
As noted in our V-4 owners manuals, secure the motor by bolting the stern brackets to the transom with the bolts, washers and nuts provided with the tool kit.
When installing a 50 H.P. motor, make sure at the time of installation that you use the transom plate and stern bracket bolts, also the stern bracket clamp.
For extreme usage, on the 65 H.P. motor, accessory stainless steel screws P/N 313672 along with washers P/N 307238 and nuts P/N 307407, are available to clamp the stern brackets directly to the boat transom. These bolts would be used in addition to the transom clamps. These bolts are standard equipment on the V-4 models.
JOHNSON MOTORS Doug Cankar Technical Data Coordinator
DC/sn
NOTE: Post on your 50 H.P. thru 125 H.P. index under the heading "Lower Unit".

Factory references

Hardware specified: stainless-steel screws P/N 313672, washers P/N 307238, and nuts P/N 307407.