Back to previous page

SB-1313 - Defective Cylinder to Crankcase Bolts

Issued January 1973, this Johnson Service Bulletin identifies affected serial-number ranges for 1973 85, 115 and 135 H.P. outboards, explains how to recognize engines already modified, and specifies modification kit 386421 for engines requiring replacement bolts.

Original Johnson Service Bulletin letterhead
SB-#1313

January, 1973

SUBJECT: Defective Cylinder to Crankcase Bolts

MODELS: 1973 85, 115, 135

We recently learned that some 1973 Johnson 85, 115 and 135 H.P. engines may have been assembled with defective crankcase to cylinder bolts. The bolts in question (P/N 317926) are the upper two. The engines in question fall within the following serial number blocks.

85ESL73From 3856026Through 3857200
115ESL73From 3862901Through 3864550
135ESL73From 3871976Through 3873625

Several weeks ago, we contacted those dealers who originally bought these engines advising them of the problem and how to fix it. However, since it is possible that some of these engines are no longer in the selling dealer's territory, the bolts may not have been replaced.

If any engine within the serial number block listed above is brought into your shop for service, please check to determine if the bolts have been replaced. All engines which have had the bolts replaced can be identified by three punch marks in the area shown.

Factory diagram showing the location of three punch marks identifying modified engines
(over)
PAGE 2SERVICE BULLETIN  SB-#1313
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
▣ NOTEIt is vital that every engine within the serial number blocks listed be modified since a defective bolt may break resulting in extensive damage to the powerhead.

If you find an engine which has not had the bolts replaced, order a modification kit (P/N 386421) from the Johnson Service Department. The kit includes detailed installation instructions and a return mailing bag for the defective screws. Place the defective screws in the mailing bag, fill in the required information on the tag attached to the bag and mail the bag and screws to the Johnson Service Department.

IMPORTANT - Use one bag for each engine modified. Do not enclose the screws from more than one engine in a bag. The completed tag on the mailing bag is your claim for labor reimbursement - make sure it is legible. Upon receipt of the mailing bag and original screws, a $10.00 labor check (for each engine modified) will be forwarded to you.

JOHNSON OUTBOARDS

J. R. Penland

Manager, Technical Services

JP/sn
NOTE: Post on your 85, 115, 135 H.P. indexes under the heading
"Powerhead".