
SB-#1320
June, 1973
SUBJECT: Electrical Trouble Shooting - Remote Control
ON MODELS: All with Magneto CD Ignition
If the key switch or the control box ground circuit are defective,
the result may be one of two things:
1. You may not be able to turn off the engine with the
key switch.
2. You may get a shock when touching the control box.
If either of these symptoms are reported, check the unit as follows:


NOTE
Disconnect battery before starting tests.
1. Remove throttle and shift control cables from engine to eliminate
possibility of reading a false ground.
2. Using an ohmmeter set to the low ohms scale, check for good ground
between ground terminals of engine and control box. If ohmmeter
shows a high or infinite reading, the cause of excess resistance
must be determined and corrected.
3. Check the ignition switch and wiring to determine if it is defec-
tive. This can be done by first removing the black/yellow stripe
lead from power pack ignition switch terminal (terminal 5 on 50 H.P.,
6 on 65 H.P. or 1 on 85-135 H.P.) and then connecting ohmmeter
(over)
PAGE 2 SERVICE BULLETIN SB-#1320
between engine ground terminal and loose end of black/yellow
stripe lead. With ignition switch in "off" position, meter
should show low resistance. If reading is high or infinite,
the wiring or switch is defective and must be repaired or
replaced.

NOTE
Any electrical connections bared during tests should be recoated
with liquid neoprene (P/N 315417).
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DL/sn
NOTE: Post on your 50 thru 135 H.P. indexes under the heading
"Electrical".