SB-1325 - New Trailering Lock Arm

Issued October 1973, this Johnson Service Bulletin explains retrofitting the 1974 trailering lock arm to selected 1973 outboards and provides an exploded parts diagram and eight-item parts list.

Johnson Service Bulletin factory letterhead
SB-#1325
October, 1973
SUBJECT: New Trailering Lock Arm
ON MODELS: 1973 65 (long), 85, 115 and 135 H.P.
Many dealers have noticed the new trailering lock arm being used on 1974, 70 H.P. (long) 85, 115 and 135 H.P. engines and have asked if the system can be used on older engines. The 1974 trailering lock arm can be fitted to any 1973, 65 H.P. (long), 85, 115, and 135 H.P. engine. All parts can be obtained from your parts distributor. Installation procedure can be found in the equivalent model 1974 service manual.
Exploded diagram of trailering lock arm and related components
(over)
PAGE 2SERVICE BULLETIN
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
The parts needed are listed below:
REF. NO.PART NO.DESCRIPTIONQTY. REQ'D
1.319808Spring Clip2
2.319961Bushing, arm2
3.319962Detent, arm1
4.319979Rod, reverse lock release1
5.319980Pivot pin, shock absorber1
6.319983Transfer1
7.386323Tilt Lock - 60°1
8.386684Trail lock arm assembly1
JOHNSON OUTBOARDS
D. J. Leinonen Technical Data Coordinator
DL/sn
NOTE: Post on your 65 thru 135 H.P. indexes under the heading "Lower Unit".