SB-1332 - Defective Pivot Screw P/N 122680
Issued January 1974, this Johnson Service Bulletin warns of potentially brittle pivot screws in power tilt and trim units and explains how to identify and replace them. Both original factory figures and the affected serial-number ranges are reproduced below.

SB-#1332
January, 1974
SUBJECT: Defective Pivot Screw P/N 122680
ON MODELS: 115ETL74, 135ETL74 or 1973 or 1974, 65
through 135 H.P. with Accessory Trim &
Tilt Kit Installed
▣ NOTE
We recently learned that a quantity of upper pivot screws on the power tilt and trim units were made from the wrong material. When this material is made into bolts in the usual manner, structural changes may occur in the material which cause it to become brittle. If this occurs, the bolts may break in the thread area allowing the tilt and/or trim cylinders to come loose. This in turn may result in damage to the motor or power trim unit. Since introduction of the tilt and trim, four different screws (in three visually different styles) have been used. See Figure 2.

Please check any tilt & trim kits which you have in stock. Also, please have any customers who have purchased the 115 H.P. or 135 H.P. TNT or one of these kits from you, bring his rig in.
(over)
PAGE 2 SERVICE BULLETIN SB-#1332
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Check the pivot screws by touching a magnet to the head of each one. If the magnet is attracted to the screw and it has a trademark on its head as shown in Figure 2, panel "A", it should be replaced. Removal can be easily accomplished by tilting the engine to the full up position. In this position all pressure is off the port pivot screw. Remove and replace this one first. When removing the starboard pivot screw, lift the gearcase slightly while removing and replacing the screw. Torque the new screws to 10-12 foot pounds.
Obtain the replacement screws from your parts distributor.
If the old screws were from a trim and tilt kit P/N 172670, send the old screws and a warranty claim to the OMC Parts & Accessories Division, Galesburg, Illinois. Upon receipt of the claim, a credit voucher for the parts and a $3.50 labor check per changeover will be issued.
If the old screws were removed from a 115ETL74 or 135ETL74 Johnson outboard, return the old screws and a completed warranty claim to Johnson Outboards, Service Department, Waukegan, Illinois 60085. Upon receipt of the claim, a credit voucher for the parts and a $3.50 labor check per changeover will be issued. For your information we have listed the serial numbers of the engines which may have defective bolts installed in the trim and tilt unit.
115ETL74 4097055 through 4097144
135ETL74 4098217 through 4098502
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/sn
NOTE: Post on your Miscellaneous index under the heading
"Accessories".