SB-1333 - Water in Lower Cylinder
Issued in January 1974, this Johnson service bulletin describes a modification to the exhaust housing of 1971-1974 50 H.P. outboards to reduce back pressure that can allow water into the lower cylinder.

SB-#1333
January, 1974
SUBJECT: Water in Lower Cylinder
MODELS: 1971 thru 1974, 50 H.P.
NOTE
If a 50 H.P. engine is brought in for service and the condition
is diagnosed as water in the lower cylinder, it may have been
caused by excessive back pressure in the exhaust system. Exces-
sive back pressure is usually the result of running with the
exhaust tube too deep in the water (as in houseboat, barge or
other displacement hull applications). To eliminate the back
pressure, we have added six additional ¼" exhaust relief holes
to the inner exhaust housing.
If water in the cylinder is not due to leaking cylinder head,
exhaust manifold gaskets or porous cylinders, you should modify
the exhaust housing. This can be most easily done by using a
¼" drill bit and, using the six original ¼" holes as drill guides,
drilling through the exhaust housing. See illustration.
Models built after the following serial numbers already have the
additional exhaust relief holes.
50ES74 S/N 4038150
50ESL74 S/N 4043986
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
NOTE: Post on your 50 H.P. index under the heading "Lower Unit".
Factory publication notes
The bulletin identifies serial-number cutoffs 50ES74 S/N 4038150 and 50ESL74 S/N 4043986. Earlier engines may require inspection and modification after other potential sources of water entry have been excluded.