Back to previous page

SB-1342 - Piston Failures

Issued May 1974, this Johnson Service Bulletin discusses low-octane fuel and piston failures in 1973-74 135 H.P. outboards, specifying carburetor jet changes and revised ignition timing. The original factory instructions are reproduced below as searchable text.

Johnson Outboards Service Bulletin factory letterhead
SB-#1342

May, 1974

SUBJECT: Piston Failures

ON MODELS: 1973-74, 135 H.P.

NOTE

Our investigation has shown that the octane number of some brands of regular fuel is lower than the 94 research octane (89 posted octane) available in the past and is the cause of some powerhead failures. It is also possible, as an economy move, the owner may purchase a lesser grade of fuel. If you have 1973 and 1974 engines which have had a piston failure (one that looks like the top has melted), low octane gasoline should be suspected as the cause.

If you have experienced this type of failure or if you are suspicious of the fuel in your area, WE RECOMMEND THE FOLLOWING CHANGES ON 1973-74, 135 H.P. ENGINES:

1.

Change the carburetor main metering jets.

1973 135 H.P. use P/N 320502 (76C) in place of P/N 318657 (73C)

1973 135 H.P. use P/N 317488 (72C) in place of P/N 319776 (69C)

These jets are being installed on 1973-74 replacement carburetors and late 1974 production motors (early 1974 carburetors factory equipped with 72C jets can be identified by the number "72" stamped adjacent to the part number on the carburetor).

2.

Readjust the spark advance to 20° BTDC rather than the 22° BTDC specified in your service manual.

Although these changes will increase the fuel flow about .5 gallon per hour at wide open throttle, they will provide an increased tolerance for low octane fuels.

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

NOTE: Post on your 135 H.P. index under the heading "Carburetion".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Inductive Ignition Timing Light & Feeler Gauge Set

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 320502

Search for original or compatible replacement part 320502. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.